Honda VT1300 Forum banner
1 - 2 of 2 Posts

·
WHYNOT
Joined
·
745 Posts
Discussion Starter · #1 ·
Just a heads up for all. Had a windshield nut fall off the other, noticed a few others were a little loose. Snugged em all up and replaced the missing one, no biggie.
 
  • Like
Reactions: Bigsk8r

·
Registered
Joined
·
195 Posts
Just a heads up for all. Had a windshield nut fall off the other, noticed a few others were a little loose. Snugged em all up and replaced the missing one, no biggie.
Ironically, during a ride this morning, I noticed one missing. With no dealers open, and no desire to put substandard hardware on board, I did something different.

The stock windscreen has six identical cap nuts, four on the upper bar and two toward the bottom. All six face the driver and the lower two are only visible at a specific angle. Given that, I went to Lowes and bought a small pack of stainless steel nuts and washers. I then replaced the two lower nuts with the stainless hardware and tightened appropriately. I took the two stock cap nuts, replaced the missing one, and now have an extra.
 
1 - 2 of 2 Posts
Top