Honda VT1300 Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
I'm considering replacing (not just raising) my ct's handlebars with aftermarket. I'm anticipating adding risers and using 1 1/4 bars. I'm also sure I'll be replacing cables, and that's fine.

My question is, has anyone else replaced their bars, and if so, what did you have to do to compensate for the step-down fm 1 1/4 -> 1" for the controls?

Thanks!

Randy aka Zoomer
 

·
Registered
Joined
·
45 Posts
Zoomer - have you replaced your bars/risers yet? I'm looking into changing my bars/risers as well. I just can't get quite comfortable enough with the stock setup. I'd like to add a little more pullback although the width of the bar is ok, but would like to also hide the cables inside the bars. There seem to be a few options out there; just wondering if you made the switch and what you wound up with.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top