Honda VT1300 Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
The rest of the story, well with guidance from Brew a Fury owner on this Forum I re-approached the task of replacing the turn signal assembly on the Sabre.
Things are so much simpler when you know the short cuts.

I removed the side covers, the seat, the two pop clips at the front of the fender, and off it came, and then there they were, the wiring quick clips for the turn signals, stop light, and the licenses plate light. All very easy to access, everything went quick after that.

Oh, and the fender is all ABS plastic, held up by the metal frame work beneath as seen in the photos.

See attached photos:

View attachment 86 View attachment 87 Tire Wheel Light Automotive tire Vehicle
View attachment 84 View attachment 85 View attachment 83
 

Attachments

·
Registered
Joined
·
7 Posts
Discussion Starter · #3 ·
1 - 3 of 3 Posts
Top