Honda VT1300 Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter · #7 ·
Also, what did you use to cut the rear fender/license plate holder or is that a kit?
I have a cutting wheel I used on the plastic. I cut the plastic just under the plate light then I took the reflector from the plate holder and put it over the hole left for the plate light, then used sand paper to smooth it out. I cut the bottom "V" shaped part of the frame off where it meets the light part of the frame. Hope this makes sense to you.
 
1 - 8 of 8 Posts
Top