My previous post on this was getting too long, thought I would post this for anyone wanting pullback risers without needing to change stock lines or cables. These have a 3" rise and 1.5" pullback. Instructions were really good, have to route all the cables behind the tree, so clutch cable has to be disconnected and you have to disconnect the whole throttle assembly from the bars so you can feed them behind the tree. Also have to drill out the handlebar bolt holes in the tree to half inch to get the new bolts through. Overall I was nervous because I'm not a big wrencher but it went fine, and OMG does the new position of the bars feel better! I can lean back into my backrest now.
The risers can be bought at refined cycle: http://refinedcycle....te-1300-HR3.htm. Instructions are under the tab called "Installation help: http://www.refinedcy... Sabre 1300.pdf.
Here are a few pics, took me a couple of hours because I went slow. In the pics it looks like the throttle cables are tight, but they aren't there is play there.
The risers can be bought at refined cycle: http://refinedcycle....te-1300-HR3.htm. Instructions are under the tab called "Installation help: http://www.refinedcy... Sabre 1300.pdf.
Here are a few pics, took me a couple of hours because I went slow. In the pics it looks like the throttle cables are tight, but they aren't there is play there.