Dimensions for Transport? - Honda Stateline Forum VT1300CR - VT Cafe - Forum for Honda VT1300 Series Bikes (Sabre / Stateline / Interstate)

Jump to content


Photo
- - - - -

Dimensions for Transport?


  • Please log in to reply
8 replies to this topic

#1 ClutchDriver

ClutchDriver

    Newbie

  • Members
  • Pip
  • 5 posts
  • Bike Info:VT1300CR Stateline

Posted 13 September 2020 - 10:48 PM

Hi,

 

I recently bought a 2012 Stateline at auction sight unseen. Before I drive 900 km to pick it up, I'm looking for more details on its size, so I can determine whether it will fit inside my minivan or on my tow dolly. If you have access to one, could you please send me answers below? I find motorcycle specs so much less detailed than car specs; why don't they even post the HP & torque? They only post the wheelbase, not the total length.

 

Highest point on handlebars (without mirrors):

Highest point with mirrors:

Highest point with windshield:

Length from front to back (including wheels/tires):

 

Thank you in advance, I appreciate any information even if you don't have all the answers.



# Advertisement

Advertisement

Posted Today, 11:06 PM



#2 Bob J

Bob J

    Advanced Member

  • Moderators
  • 4622 posts
  • LocationThe Driftless Area of Wisconsin
  • Bike Info:2010 Sabre
  • Miles on bike?:>25K not too bad for a bike that's parked for almost six months of the year!

Posted 14 September 2020 - 10:51 AM

Hey CD, I have a Sabre and the measurements will be similar but not exact.

 

I'll drop them here when I get a chance later today.



#3 ClutchDriver

ClutchDriver

    Newbie

  • Members
  • Pip
  • 5 posts
  • Bike Info:VT1300CR Stateline

Posted 14 September 2020 - 03:10 PM

Thanks, Bob.

#4 Bob J

Bob J

    Advanced Member

  • Moderators
  • 4622 posts
  • LocationThe Driftless Area of Wisconsin
  • Bike Info:2010 Sabre
  • Miles on bike?:>25K not too bad for a bike that's parked for almost six months of the year!

Posted 14 September 2020 - 06:51 PM

OK.....

I had to deal with some B.S. this afternoon, but here I am.

 

I had my daughter help with measuring it as close as possible.

 

No measurement for windshield as mine is a boulevard, and if yours has one its probably waaay taller!

The Sabre's bars are more narrow than the Stateline or Interstate, but I'm guessin' the height is almost the same.

 

Longest measurement (Tip to tip of tires) of bike 2.56m

Height to top of bars 107cm

To top of mirrors 120cm

Handlebar width 80cm

 

I hope that helps!  :)



#5 ClutchDriver

ClutchDriver

    Newbie

  • Members
  • Pip
  • 5 posts
  • Bike Info:VT1300CR Stateline

Posted 14 September 2020 - 10:01 PM

Thanks, that's helpful. It's quite tight for fitting in my minivan - my door rear opening is around 105 cm tall, though the ceiling does get higher further in. Length is OK, as I have almost 3 m, so as long as I can remove the mirrors and windshield and wiggle it through the door it will fit.

#6 Yellowiron

Yellowiron

    Advanced Member

  • Members
  • PipPipPip
  • 79 posts
  • LocationUK
  • Bike Info:VTX1300 and VT1300CT interstate. Husqvarna Nuda 900 and 11 others!
  • Miles on bike?:18426 on the VTX and 106.497 on the interstate.

Posted 18 September 2020 - 11:39 AM

104.3 inches long

38,2 inches wide



#7 Bob J

Bob J

    Advanced Member

  • Moderators
  • 4622 posts
  • LocationThe Driftless Area of Wisconsin
  • Bike Info:2010 Sabre
  • Miles on bike?:>25K not too bad for a bike that's parked for almost six months of the year!

Posted 19 September 2020 - 12:04 PM

FWIW, If the bike is still too tall for the front end to roll into the van, you could compress the shocks and release some air out of the front tire.

 

Cheers!



#8 Yellowiron

Yellowiron

    Advanced Member

  • Members
  • PipPipPip
  • 79 posts
  • LocationUK
  • Bike Info:VTX1300 and VT1300CT interstate. Husqvarna Nuda 900 and 11 others!
  • Miles on bike?:18426 on the VTX and 106.497 on the interstate.

Posted Yesterday, 07:13 AM

I once moved a BSA M21 600 single I had just bought and managed to get it into the back of a Citroen 2CV! And managed to hit 80mph with a passenger too! So anything is possible!!

 

Another way around it is to find a piece of steel bar that will fit in the forks where the front wheel spindle  goes through, then put a wheelbarrow wheel and tyre on the bar with some spacer tubes, in place of the front wheel.That works, cos I have done it, in my youthful past!



#9 Bob J

Bob J

    Advanced Member

  • Moderators
  • 4622 posts
  • LocationThe Driftless Area of Wisconsin
  • Bike Info:2010 Sabre
  • Miles on bike?:>25K not too bad for a bike that's parked for almost six months of the year!

Posted Yesterday, 11:27 AM

Yep! . . . . where there's a will there's a way!






0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users